Excellent For Every Machining Operation - Formula "77" for Tougher Service

Meets requirements of OSHA - NASA - AEC - EPA

NOTE: This product listing is for a case (4) 1 Gallon Jugs, for any other quantity go HERE

Formulas “77” and “78” will assure superior results and maximum safety conditions from your spray mist system regardless of make.

All metal cutting applications generate heat due to metal deformation and chip friction at the tool chip interface. Coolants allow for this heat to be minimized or removed from the operation. By removing the heat generated in the operation, tool life increases and part finish is improved. Both coolants can help boost your output, improve your micro-finishes, and extend your tool life.

Our spray list coolant will not cause:

• Dermititis
• Rust
• Stains
• Plugged lines and nozzles

Safe for People, Machines and Parts

Kool Mist contains no halogens or sulfides and is totally free of dangerous or otherwise troublesome chemicals. It is harmless to operators and ends problems of mist fog fumes. Kool Mist will not cause corrosion, buildup, rancidity or objectionable odors. Neither will it create rust or stains or machined parts even when diluted 32:1 with water. As a result, it sharply reduces parts spoilage, eliminates employee health claims and precludes problems with health and environmental agencies such as OSHA.

100% Synthetic Biodegradable

Both Kool Mist coolant formulas are biodegradable. Greatly reducing storage and disposal concerns and procedures. Coolant may be disposed of without special treatment and with no adverse environmental effect.

A Little Does a Lot

Kool Mist comes in concentrated form, and may be diluted with water solutions up to 33 gallons of mix (32:1), or enough for 33 shifts of eight hours each at average rate of use (A case = 132 shifts of eight hours). Therefore, making coolant costs under $0.03 an hour !

Download Safety Data Sheet