PORTaMIST #60M12 Unit includes: the PORTaMIST unit which comes with air and coolant hoses, heavy duty magnetic base, simple single knob control, and 12" flexible Loc-Line® positioner.

The model 60M12 is to be used with your own Tank or Sump. Kool Mist general purpose models are best used in production operations that require minimal set up changes. This unit is a similar design to the Lite Duty, but equipped with longer lines and nozzles for heavier use. The general purpose models generate a wider spray traveling further distance than the Lite Duty models.

Air supply required

Simplest of the Systems: The controls of these units are mounted permanently to the machine, close to the operator and the cut.

No Coolant Tank Furnished: Coolant mix may be placed in the machine sump, or in any clean container that will not contaminate the coolant. If the sump is used the conventional flood coolant pump must be made inoperative.

Coaxial Coolant Line: Coolant and compressed air are not mixed until they reach the nozzle. To overcome the need for dual lines, Kool Mist has developed a coaxial line, or a hose within a hose. Coolant line exteriors may be nylon braided for normal duty, or metal braided from protection from hot chips and abrasion.

Easy to Use Control: Output from each nozzle is regulated by a single knob on the control. Mist Spray may be turned on or off instantly to co-ordinate with the cutting cycle, and the spray mix made lean or rich as needed. Nozzle position can be a permanent mount or the flexible magnetic base.

**NOTE: Straight nozzle is standard. 45 and 90 deg. nozzles are available.